Question before entering:
One of
Ford mustang GT 2006 owner consult obdtool.co.uk engineer
that he need a special OBDII scanner to read the instrument cluster and reflash it.
Engineer replay:
The instrument cluster only holds mileage for
the 05-09's. You need a WIFI VCMII diagnostic system with IDS software
to do any of the programming, and/or transfer of information from one component
to a new one.
Equipment:
Ford VCM
2 scanner and Integrated Diagnostic System IDS software (V86, V94 or V96)
Programmable
Module Installation Instructions:
1)
Programmable Module Installation (PMI)
Using (IDS) When the Original Module is Available
NOTE: Following module installation, some
modules require a separate learning procedure be 3. From the Toolbox icon,
select Module carried out. For adaptive learning and calibration Programming
and press the check mark. instructions, refer to the specific module removal
and installation procedures.
1. Connect the VCMII IDS and identify the
vehicle as normal
2. From the Toolbox icon, select Module
ignition key to the OFF position, and press the Programming and press the check
mark.
3. Select Programmable Module Installation.
4.
Select the module that is being replaced.
5. Follow the on-screen instructions, turn the ignition key to the ON
position, and press the check mark.
6. Install the new module and press the
check mark
7. Follow the on-screen instructions, turn
the mark. ignition key to the ON position, and press the check mark.
8. The IDS downloads the data into the new
Complete. module and displays Module Configuration Complete.
9. Test module for correct operation.
2)
Programmable Module Installation (PMI)
Using IDS When the Original Module is NOT (VCM) and Integrated Available
NOTE: Following module installation, some
hardware, or equivalent scan modules require a separate learning procedure be
tool carried out. For adaptive learning and calibration instructions, refer to
the specific module removal and Installation procedures.
1. Install the new module
Related
document can be found here:
2. Connect the VCM2 IDS and identify the
vehicle as normal.
3. From the Toolbox icon, select Module ignition key to the OFF
position, and press the Programming and press the check mark.
4. Select Programmable Module Installation.
5. Select the module that was replaced.
6. Follow the on-screen instructions, turn
the ignition key to the OFF position, and press the Programming and press the
check mark.
7. Follow the on-screen instructions, turn
the ignition key to the ON position, and press the check mark.
8. If the data is not available, the IDS
displays a screen stating to contact the As-Built Data check mark. Retrieve
the data from the technician service publication website at this time and press
the check press the check mark.
9. Enter
the module data and press check mark
11. Test
module fro correction operation.
没有评论:
发表评论